ASUS TW300-E5/PI4 5-17
5.3.6 Resetting disks to Non-RAID
Take caution before you reset a RAID volume hard disk drive to non-RAID.
Resetting a RAID volume hard disk drive deletes all internal RAID structure on
the drive.
To reset a RAID set hard disk drive:
1. From the utility main menu, select 3. Reset Disks to Non-RAID, then press
<Enter> to display this screen.
2. Use the up/down arrow key to highlight the RAID set drive you want to reset,
then press <Space> to select.
3. Press <Enter> to reset the RAID set drive. A conrmation message appears.
4. Press <Y> to reset the drive or press <N> to return to the utility main menu.
5. Follow steps 2 to 4 to select and reset other RAID set drives.
[ RESET RAID DATA ]
Reset ting RAID da ta wi ll re mov e inter nal RAI D struc tures
from the selected RAID disks. By removing these structures,
the drive will revert back to a non-RAID disk.
WARNING: Resetting a disk causes all data on the disk to be lost.
Port Drive Model Serial # Size Status
0 XXXXXXXXXXXX XXXXXXXX XX.XGB M e m b e r D i s k
1 XXXXXXXXXXXX XXXXXXXX XX.XGB Member Disk
Select the disks that should be reset.
[↑↓]-Previous/Next [SPACE]-Selects [ENTER]-Selection Complete
5.3.7 Rebuilding the RAID
This option is only for the RAID 1, RAID 5 and RAID 10 level.
Rebuilding the RAID with other non-RAID disk:
1. If one member of physical SATA Hard disk within the array is off-line or failed,
the status of array will become to be degraded from normal. The following
displays as:
To Next Page