Installation & Servicing instructions ATAG A-Series
39
Always replace the gaskets of the removed parts during maintenance, if
required.
Put the boiler back into operation and carry out a ue gas analysis (see page 34).
Always put back the cover after (maintenance) work and secure it with screws
A, B, C and D.
In the event that parts require replacement, use only genuine parts supplied by
ATAG Heating UK Ltd.
Please contact your installer or ATAG Heating UK Ltd. for further details. Contact details
can be found on the back page of this manual.
After servicing, complete the relevant Service Interval Record section of the
Benchmark Checklist located on the inside back page of the document.
13.3 User's instructions
Advise the user that for continued efcient and safe operation, the boiler should be ser-
viced at least once a year by qualied servicing company. It is important and strongly
recommended that arrangements are made for a maintenance agreement with a qualied
servicing company to ensure regular servicing of the boiler.
Please contact ATAG Heating UK Ltd. for further details. Contact details can be found
on the back page of this manual.
13.4 Maintenance frequency
ATAG Heating UK Ltd advises an annual inspection, with a full strip down service as
required, depending on the CO, CO
2
and ratio gures.
13.5 Warranty
For the warranty conditions we refer to the Warranty Card that is supplied with the boiler.
Figure 13.2.l
To Next Page
Loading...
Need help?
General
