EN 14
When the appliance is fi rst plugged in, the DISPLAY lights up. After fi ve seconds, the Clock
symbol and “12:00” blink on the DISPLAY.
Setting the Clock (example 15:15)
1
Turn the MODE SELECTOR to the
“OFF” position.
2
Press CLOCK. The “12” starts blinking.
3
Turn the MULTI-FUNCTION
SELECTOR to set the hour.
4
Press CLOCK again. The “00” starts
blinking.
5
Turn the MULTI-FUNCTION
SELECTOR to set the minutes.
6
Press CLOCK again.
Note
• If you want to change a setting after you have pressed a button, the setting starts blinking. You
can only change this setting during blinking. If it has stopped blinking, you have to press the
button so it will start blinking again.
SETTING THE CLOCK
To Next Page
Loading...
