EN 53
DESCALE MODE (CONTINUED)
5
When it has progressed for about
40minutes, the machine displays
“10:00” and stops operating with a
beep.
Remove the tank and empty any
remaining mixed water.
Wash the tank with water and fi ll up to
the maximum line with clean water.
Put it back into the main unit.
When ‘10:00’ is displayed, you have
to operate the rinse mode within
25minutes. If you do not, the set
will be reset after 25 minutes and
then you will perform the descale
mode again.
6
Automatically start after 5 seconds.
A rinse mode takes place with clean
water. After 10 minutes later, the
descale mode will be completed.
7
When done, the machine will make a
beep. Empty both the tank and the drip
tray and clean the tank with water.
8
Open the door and wipe inside the
cooking cavity with a dry cloth.
Note
• We advise to use NOKALK/DLS when you descale the machine. NOKALK/DLS is a highly
e ective descaler made exclusively from natural, totally biodegradable substances. It is non-
corrosive, non-aggressive and has no environmental impact.
As well as being an e ective descaler, it also has an antimicrobial sanitising action, thus helping
to ensure the hygiene of the machine’s internal components, preserve the taste of the food
over time and extend the working life of the machine.
• For subsequent descaling operations with NOKALK/DLS, descaling solvent can be purchased
from www.atag.nl
• Water which is used for steam cooking, contains calcium and magnesium. Through heating,
water evaporates and only the fl oating materials (minerals) remain (not harmful to humans).
• If the descaling cycle is interrupted before completion, the programme must be started again
from the beginning.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
