EN 20
General
This appliance should only be connected by a registered installer! The
electrical connection must comply with national and local regulations.
Warning!
This appliance must be earthed at all times.
Installation, maintenance, or repairs should only be carried out by
professionals who are authorised by the manufacturer, as failure to do
so will void the guarantee.
The device should be disconnected from the mains prior to installation,
maintenance or repairs. The device is only disconnected from the
electric power if:
• the main switch of the domestic electrical system is switched off, or
• the fuse of the domestic electrical system has been completely
removed, or
• the plug has been pulled out of the socket.
Faulty parts may only be replaced by original ATAG parts. Only those
parts are guaranteed by ATAG to meet the safety requirements.
To avoid dangerous situations resulting from any damage to the
connecting cable, this should only be replaced by the manufacturer, the
manufacturer’s service organisation or suitably qualified persons.
INSTALLATION
To Next Page
Loading...
