Online product activation
Connecting the ATAG ONE
Zone
controller
to the internet
After you have installed the product, turn on the power.
ATAG ONE
Zone
turns on and the display reads “Select language”;
follow the step-by-step instructions for the basic settings until
you are prompted to configure the Wi-Fi network.
Once installed, turn on the power. You will be
asked to “Select a language” and then follow
the step-by step instructions for the
basic settings.
English
Nederlands
Français
Italiano
Deutsch
Language
Push to conf irm
NOTE: If the Wi-Fi connection was not configured during the first
start up then go to the Connectivity menu.
Select “ON/OFF WIFI NETWORK” and select “ON”.
Then select the new menu option called “NETWORK
CONFIGURATION” and follow the step-by -step instructions.
Further information can be found including a “how to” video
“How to connect an ATAG ONE Zone controller (2019 onwards)”
Visit: www.atagheating.co.uk/zone
Basic settings:
12
CONNECTIVITY
Push to conf irm
To Next Page
Loading...
Need help?
General
