Installation instructions E-SHR series page 6
5.1 Dimensions
5 Mounting of the boiler
The boiler can be mounted practically to any wall with the
suspension bracket and the included fixing equipment.
The wall must be flat and of sufficient strength in order to
be able to carry the boiler weight.
Above the boiler there must be at least 250 mm working
space in order to be able to fit a twin supply and exhaust
system or a coaxial flue system. On both sides of the
boiler at least 10 mm must be reserved in connection with
fitting or removing of the casing. The location of the boiler
can be determined by using the template.
Remove the casing of the boiler. The casing is also the
airbox of the boiler and is secured with a screw behind the
door at the front. Also the four quick-release fasteners (2
at the top and 2 at the bottom) should be secured with a
screw.
First remove the screws before loosening the
quick-release fasteners.
Tighten the screws again when replacing the
housing.
Lift the boiler only at the boilers rear wall.
Dimensions (*see figure 4) table 1
tinufoepyt
51RHS-E
42RHS-E
T42RHS-E T53RHS-E
A thgieh
mm056056056
B thgiehknatnoisnapxehtiw
mm- - 078
C htdiw
mm005005005
D htped
mm593593593
E tsuahxesageulf/edistfel
mm533533533
F ylppusdnatsuahxesageulf/ertnecotertnec
mm021021021
G tsuahxesageulf/kcab
mm072072072
H epipsag/edistfel
mm052052052
J epipwolf/edistfel
mm051051051
K epipnruter/edistfel
mm053053053
L epipnoitasnednoc/edistfel
mm504504504
N epipretawdloc/edistfel
mm582582
P epipretawtoh/edistfel
mm512512
Q *gfothgnelepip
mm9191512
R *cfothgnelepip
mm040404
S *wdnak;r;fdnacfothgnelepip
mm0505061
T cepipfoertnec/kcabwdnak;*
mm626262
U *rdnag;fepipfoertnec/kcab
mm050505
To Next Page
Loading...
