AT&T 1739 User Manual

Feature setup

FEATURE SYSTEM OPTIONS
ANNOUNCE
ANNOUNCEMENT
MONITOR
• ChooseONtolistentotheannouncement
whenthesystemanswersacall.ChooseOFF
tosilenceyourendofthecall.(Thecallerswill
stillheartheannouncement.)
NOTE: Volume must be set to an audible level
to use the announcement monitor.
“Announcement
monitor is…”
NUMBER
ANNOUNCE
(Pleasesee
NOTEbelow)
• Whenthisfeatureison,thesystemwill
announcetheincomingtelephonenumber
betweenthesecondandthirdrings.
NOTE: When the number announce feature is
on and ring select is set for two rings, the unit
will answer after three rings to allow enough
time for the system to announce the caller’s
telephone number.
“Number
announce is…”
STORE NUMBER
(Pleasesee
NOTEbelow)
• Whenthisfeatureison,thesystemannounces
theincomingtelephonenumberwhenitplays
backamessage.
“Store number is…”
ACCEPT BLOCK
CALLS
(Pleasesee
NOTEbelow)
• ChooseONtohavethesystemacceptall
calls.ChooseOFFtohavethesystemrespond
toblockedcallswiththepre-recorded
announcement,“We’re sorry, blocked calls to
this number cannot be accepted,”andhangup
withoutrecordingamessage.
“Accept block
calls is…”
AUDIBLE MESSAGE
ALERT
• Whenthisfeatureison,thesystembeeps
every15secondswhentherearenew
messages.
“Message alert is…”
NOTE: For this feature to work, you must subscribe to the caller ID service from your local
telephone company. There may be a fee for this service, and it may not be available in all areas.

AT&T 1739 Specifications

General

Brand	AT&T
Model	1739
Category	Answering Machine
Language	English