22
You can store up to 50 telephone numbers and names in memory at the
base and each registered handset. Memory information is stored
independently at the base and each handset. Changes made to memory at
one location do not affect memory at other locations. The softkey menu
appears the same on the base and handset screens.
Store a Number and Name in Memory
1 Start
from
the
“idle”
screen.
2 Begin entering the number you want
to store. Press to enter a
dialing pause if you wish. Press
when finished.
3 The screen displays:
4 Use the chart below to enter a name to be stored with this number.
Press to enter a space; press if you make a mistake.
Presses
Dial Key 1 2 3 4 5 6 7 8 9
1 &‘ , .1
2 AB C a bc 2
3 DE F d ef 3
4 GH I ghi 4
5 JK L j kl 5
6 MN O m no 6
7 PQ R S pq r s 7
8 TU V t uv 8
9 WX Y Z wx y z 9
*
*
0 0
# #
5 Press . The entry is stored and the screen returns to the
idle screen.
NOTE: If the memory is full, the screen displays PHONEBOOK IS FULL!
and exits without saving the entry.
SAVE
CLR
MEM
PAUSE
TELEPHONE MEMORY
AT THE BASE OR HANDSET
BASE
RDL MENU MEM
HANDSET 1
RDL MENU MEM
555-1234
PAUSE MENU MEM
ENTER NAME
-
CLR SAVE
or
22
To Next Page
Loading...
