5
2 Install the handset battery.
Use only the battery supplied with this handset or AT&T
Accessory Battery Model 2401, SKU# 91077.
Handset Charger Installation
1 Connect the power cord. Feed the
power cord through the strain-relief
channel on the bottom of the handset
charger. Then plug the cord into an
electrical outlet not controlled by a
wall switch.
INSTALLATION
b) Place the battery pack in
the handset. Match the
metal contacts on the
battery with the contacts
in the battery
compartment.
c) Replace cover
by sliding it on
its track up
over battery
case until it
snaps firmly
into place.
a) Remove
battery
compartment
cover by
pressing on
indentation
and sliding
downward.
CHARGING Light: on when
handset is in charging stand
2462_00_1 ATT CIB 1/28 1/28/02 9:52 AM Page 5
To Next Page
Loading...
Need help?
General
