AT&T 610 - Spills

User's Guide
August 1985
Options can cause erratic operations, so it is important to
ensure they are set up properly.
When the terminal is installed, the existing values should
be checked to ensure the trouble is not option related.
If the trouble still exists after the tests have been run
and the options verified, report the trouble to your service
representative giving as much information as possible.
Routine Cleaning
Keeping the terminal clean is an easy matter. Use a
slightly damp paper towel to wash or clean glass, plastic, and
painted surfaces.
When oily substances are present on the terminal, a fair
amount of rubbing may be required. This is the recommended
method
of cleaning rather than using chemical solvents.
Warning 1: Unpainted plastic parts may be damaged by the
use of chemicals, cosmetics, and high heat.
Warning 2: Painted parts may be damaged by the use of
chemicals, glues, adhesive-backed tapes, and
adhesive-backed labels.
Spills
Care should be taken not to spill any liquid into the
keyboard. If a spill occurs, it is imperative that the terminal
be turned off immediately. The keyboard should then be
disconnected and turned upside down and all excess liquids
allowed to drain. The keyboard should be left upside down for
several hours until completely dry. If the keyboard self-test
fails when reconnected, after the dJtying time, call for service.
Maintenance
Page 10- 3