AT&T 610 - Changing Fkey Labels and Strings

Terainal Setup
Page 5-10
Changing ¥key Labels and Strings
To change a label or string, the following steps should be
taken:
User .... s Guide
August 1985
1. Move the cursor to the beginning of the label or string to
be changed with the cursor positioning keys or the PREVIOUS
FIELD or NEXT FIELD screen-labeled keys.
2. Enter the desired characters from the keyboard.
Depressing the DEFAULT VALUES' screen-labeled key changes
all labels and strings back to their default values (the default
values are shown in Figure 5-2).
Depressing the NEXT SETUP screen-labeled key brings up the
Expansion I/O Card Setup screen (if the Expansion I/O card is
present and uses the options screen). If an Expansion I/O card
is not present or present but does not use the options screen,
depressing the NEXT SETUP screen-labeled key brings up the
Options SETUP screen.
Depressing the CLEAR TO END screen-labeled key will clear
the label or string of all characters from the cursor to the end
of the label or string.
The labels and strings are stored when the USER Fkey SETUP
screen is exited by depressing the NEXT SETUP screen-labeled key
or the Set-Up root key (Fl) with the Ctrl (Control) key
depressed.