AT&T 974 - Dial a Number from the Directory; Remove a Name and Number from the Directory; Remove All Entries from the Directory

Store a temporary tone signal in a
directory number
If you have dial pulse (rotary) service, you can store tone
signals in a directory number. When you reach the place in
the dialing sequence where you wish tone dialing to begin,
press - until the screen displays:
Press E. All digits entered after this will send tone
signals.
Store a flash in a directory number
You can store the switchhook flash needed to access some
custom-calling services in a directory number. When you
reach the place in the dialing sequence where you wish to
enter a flash, press - until the screen displays:
Press E to store the flash, then continue entering the
number. Each flash counts as one digit.
JIMTERXNAMELLXX
555_
XXXXXXXXXXXXXXx
FLASHXNUMBERXXXx
JIMTERXNAMELLXX
555_
XXXXXXXXXXXXXXx
TONEXXNUMBERXXXx
63
Directory operation
Directory operation
l
ll
ll
i
ii
ii
974CIB_06 4/7/06 3:33 PM Page 63