30
Telephone operation
Basic operation
Make, answer or end a call
Handset
To make a call, lift the handset and dial the number. The
number appears on screen when dialing.
To answer a call, lift the handset.
To override automatic line selection, lift the handset,
then press and release a LINE button.
— OR —
Press the LINE button for the desired line and lift the
handset.
To end the call, replace the handset.
Speakerphone
To make a call, press SPEAKER. The SPEAKER light goes
on. Wait for a dial tone before dialing the number. The
number appears on screen when dialing.
To answer a call, press SPEAKER or press the LINE
button of the incoming call, then press SPEAKER.
To override automatic line selection, press SPEAKER,
then press and release a LINE button. Dial the number
within twenty seconds.
— OR —
Press the LINE button for the desired line and press
SPEAKER. Dial the number within twenty seconds. To end
a call, press SPEAKER again.
NOTES:
If one line is in use, any calls made or answered on the other line
will use the same mode (handset, speakerphone, or headset) already
in use.
If you dial a telephone number with more than 16 digits, the screen
will display only the last 16 digits.
When making a call, the telephone uses the primary line
programmed (See Set the primary line on page 19). When answering
a call, it automatically selects the ringing line.
If headset is programmed as the default mode (see Set preferred
mode on page 21), you must press SPEAKER to activate the
speakerphone.
1.
2.
3.
4.
To Next Page
Loading...
Need help?
General
