AT&T A50 - Advanced Router: LAN Settings

23
To back up your device settings into a file to your computer, click Back Up Now button.
The backup setting file (hotspot_cfg.bin) will be created on the downloads folder of your
device.
To restore the device setting from the backup file you made, follow the steps below:
a. Click Choose File and select the backup file you saved.
b. Click Restore now. Your mobile hotspot will restart.
To restore all your device settings to its factory default settings, follow the steps below:
a. Click Factory Reset.
b. Click OK to confirm the command.
Factory Reset Button: you can disable the physical factory reset button underneath the
battery cover. If Disable is selected, pressing the button will not perform factory
reset.
AdvancedRouter
Configure LAN, Firewall, and other Router settings.
‐ LAN Settings
 IP address – The IP address for your Mobile Hotspot Web Admin page. This is also
a default gateway IP of your device.
 Subnet mask – The Subnet mask network setting for your mobile hotspot. The
default value 255.255.255.0 is standard for small (class “C”) networks.
 VPN Passthrough – When turned ON, this feature allows VPN clients on your
connected device to connect through your mobile hotspot to remote VPN servers.
 DHCP (Dynamic Host Configuration Protocol) server – The DHCP server is ON
by default. When turned ON, your mobile hotspot automatically assigns local IPs to
the devices connected to your mobile hotspot. When turned OFF, you will need to
set it up manually from the device you want to connect to your mobile hotspot.