4
5
1.2 Getting started ............................................
1.2.1 Setup
Inserting or removing the NANO SIM card/microSD
TM
card
1. Use the provided SIM pin to open the SIM tray.
2. Place the SIM card and/or the microSD
TM
* card in the correct
slot as shown.
3. Carefully close the SIM tray.
A NANO SIM card is required to make phone calls and use
cellular networks. If you have a NANO SIM card, insert it before
setting up the phone. Do not attempt to insert other SIM types
like mini or micro SIM cards, as you may damage your phone.
NOTE: microSD
TM
card sold separately.
Charging the battery
You are advised to fully charge the battery. Charging status
is indicated by a percentage displayed on screen while the
phone is powered off. The percentage increases as the phone
is charged.
To reduce power consumption and energy waste,
disconnect your charger when the battery is fully
charged, and switch off Wi-Fi, GPS, Bluetooth or
apps running in the background when not needed.
In Settings you can also lower the brightness of the
screen, and shorten the length of time before the
screen goes to sleep.
1.2.2 Power on your phone
To turn your phone on, hold down the Power/Lock key. It will
take a few seconds before the screen lights up. If you’ve set a
screen lock in Settings, unlock your phone (Swipe, Pattern, PIN,
Password, Fingerprint or Face) and display the Home screen.
If you do not know or have forgotten your unlock PIN/pattern,
contact your service provider. Do not store your PIN or patern
with your phone. Store this information in a safe place when
not in use.
1.2.3 Power off your phone
To turn your phone off, hold down the Power/Lock key until
the phone options appear, then select Power off.
To Next Page
Loading...
Need help?
General
