Multiple handset use
Push-to-talk (PTT)
Answer an incoming call during a PTT call
When you receive an outside call during PTT, there is an alert tone.
During a one-to-one PTT, press PHONE/FLASH on the initiating or
destination handset. The PTT call ends automatically and the outside call
is answered.
During a one-to-group PTT call, press PHONE/FLASH on the initiating
handset. The PTT call ends automatically and the outside call is answered.
During a one-to-group PTT call, press PHONE/FLASH on any one of the
destination handsets. That handset answers the outside call. The PTT call
continues for the rest of the PTT participants.
To leave the PTT call without answering the incoming call, press
OFF/CANCEL. The telephone continues to ring.
Make an outgoing call during PTT call
During a one-to-one PTT call, press PHONE/FLASH to get a dial tone. The
PTT call ends automatically.
During a one-to-group PTT call, press PHONE/FLASH on the initiating
handset. The PTT call ends automatically and you get a dial tone.
During a one-to-group PTT call, press PHONE/FLASH on any one of the
destination handsets. That handset gets a dial tone. The PTT call continues
for the rest of the PTT participants.
End or leave a PTT call
For one-to-one PTT calls, both initiating and destination handsets can end
the PTT call. For PTT calls to multiple handsets, the initiating handset can end
the PTT call. If any one of the destination handsets leaves the PTT call, the
call continues until all participants or the initiator hangs up.
Press OFF/CANCEL on the handset. The screen shows Push to talk Ended.
-OR-
Place the handset in the telephone base or charger, then the handset
return to idle mode.
NOTE: After PUSH TO TAL� is released, the PTT call remains open for a short time. If no one
presses PUSH TO TAL� within ten seconds, the PTT call ends automatically.
•
•
•
•
•
•
•
37
To Next Page
Loading...
Need help?
General
