Answering system
Answering system settings
Call screening
Use this feature to choose whether incoming messages can be heard over
the speaker when they are being recorded. If you turn call screening on, you
hear the incoming message. While monitoring an incoming message, you can
answer the call by pressing PHONE/FLASH on the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/SELECT
to enter the main menu.
2. Press qCID or pDIR to scroll to Answering sys, then
press MENU/SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then
press MENU/SELECT.
4. Press MENU/SELECT to select Call screening.
5. Press qCID or pDIR to choose On or Off.
6. Press MENU/SELECT to save the setting. You hear a
confirmation tone.
NOTE: For more information on call screening, see page 64.
Number of rings
You can set the answering system to answer an incoming call after two, three,
four, five or six rings. You can also select toll saver. If toll saver is selected, the
answering system answers a call after two rings when you have new messages,
and after four rings when there are no new messages. This feature allows you
to check for new messages and avoid paying long distance charges when
calling from out of your local area. By default, the answering system answers
an incoming call after four rings.
To set the number of rings:
1. When the handset is in idle mode, press MENU/SELECT to enter the main
menu.
2. Press qCID or pDIR to scroll to Answering sys, then press MENU/SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup, then press MENU/SELECT.
58
Answer ON/OFF
>Ans sys setup
>
Call screening
# of rings
CALL SCREENING
>On
To Next Page
Loading...
Need help?
General
