Appendix
Alert tones and lights
Handset alert tones
One short beep Tone of each key press, if key tone is turned on.
One long beep Indication to begin recording a message, memo or announcement.
Two short beeps
You are pressing qCID or pDIR on a cordless handset when the
volume is already at its highest or lowest setting.
-OR-
Call waiting tone.
-OR-
Error tone.
Confirmation tone
(three rising tones)
The system has completed the command successfully.
Four beeps
The other party has ended your intercom call.
-OR-
The handset has gone out of range from the base during a call.
Four short beeps Low battery warning.
Telephone base alert tones
One long beep
Indicates the start of message recording during call screening or
the end of a message playback session.
Four short beeps Registration failure tone.
Beeps every
ten seconds
Message alert.
Fast ringer tone
You are setting the ringer volume by pressing the pVOL
+
or
qVOL
- key on the telephone base.
77
To Next Page
Loading...
Need help?
General
