Answering system
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at least one
new message, the telephone base beeps every ten seconds. By
There is no audible alert at the handset.
To change the setting:
1. When the handset is in idle mode, press
MENU/SELECT to enter the main menu.
2. Press qCID or pDIR to scroll to Answering sys,
then press MENU/SELECT.
3. Press qCID or pDIR to scroll to Ans sys setup,
then press MENU/SELECT.
4. Press qCID or pDIR to scroll to Msg alert tone,
then press MENU/SELECT.
5. Press qCID or pDIR to choose On or Off.
6. Press MENU/SELECT to save the setting. You hear a
confirmation tone.
Notes:
f The message alert tone beeps only if all the following conditions are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
f To temporarily turn off the message alert tone, see page 117.
Remote code
>
Msg alert tone
MSG ALERT TONE
>On
111
To Next Page
Loading...
Need help?
General
