AT&T CL84307 - Call Screening

Answering system
110
Call screening
Use this feature to choose whether incoming messages can be heard over
the speaker when they are being recorded. If you turn call screening on, you
hear the incoming message. While monitoring an incoming message, you can
answer the call by pressing PHONE/FLASH on a cordless handset, or pressing
/SPEAKER or liing the corded handset on the telephone base.
To change the setting:
Using a cordless handset or the telephone base:
1. When the telephone is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press CID or DIR to scroll to Answering sys, then
press MENU/SELECT.
3. Press CID or DIR to scroll to Ans sys setup, then
press MENU/SELECT.
4. Press MENU/SELECT to select Call screening.
5. Press CID or DIR to choose On or Off.
6. Press MENU/SELECT to save the setting. You hear a
confirmation tone.
Note: For more information on call screening, see page 116.
Answering system settings
Voice guide
>Ans sys setup


> Call screening
# of rings



CALL SCREENING
>On


Answer ON/OFF
>Ans sys setup
> Call screening
# of rings

CALL SCREENING
>On