AT&T CL84307 - Answer an Incoming Call During an Intercom Call

Multiple handset use
50
Intercom
 If you have other registered device(s) or more than one handset, the
telephone base shows INTERCOM TO:. Use the dialing keys to enter a
specific handset number (1-9 for handsets 1-9, TONE followed by 0-2
for handsets 10-12, # for a single headset/speakerphone, # followed
by 1 or 2 for headset/speakerphone 1 or 2, or TONE followed by # for
all devices), or press CID or DIR to scroll to the desired handset and
press MENU/SELECT. The telephone base shows Calling HANDSET X or
Calling all handsets.
The destination handset(s) rings and shows Base is
calling, BASE 0 is calling or BASE 0 is calling all.
2. To answer the intercom call, press PHONE/FLASH,
/SPEAKER or any dialing key (0-9, TONE , or
#
)
on the destination handset. Both the base and the
handset now show Intercom.
3. To end the intercom call, one party presses
OFF/CANCEL or places the cordless handset back in
the charger, presses CANCEL on the telephone base,
or hangs up the corded handset. The other party hears four beeps. Both
devices display Intercom ended.
Notes:
 Before the intercom call is answered, you can cancel it by pressing OFF/CANCEL on the handset or CANCEL on the
telephone base.
 If the called device is not answered within 100 seconds, or if it is in use, on a call or out of range, the initiating device
shows No answer. Try again..
 To temporarily silence the intercom ringer, press OFF/CANCEL or MUTE/DELETE on the handset, or press CANCEL
or MUTE/DELETE on the telephone base.
 You can only use one pair of devices at a time to make intercom calls.
 For cordless headsets and speakerphones, refer to the corresponding user’s manual on how to answer and end an
intercom call.
 If a total of two cordless headset(s) and/or speakerphone(s) are registered to the telephone base, they appear as
HEADSET 1 and HEADSET 2, respectively, in the intercom menu.
Answer an incoming call during an intercom call
If you receive an outside call during an intercom call, there is a two-beep call
waiting tone.
 To answer the call, press PHONE/FLASH on the cordless handset. You can
also li the corded handset or press /SPEAKER on the telephone base.
The intercom call ends automatically. The party on the intercom call hears
four beeps. Other system devices can also answer the incoming call by
pressing PHONE/FLASH or /SPEAKER on the handset, or pressing
/SPEAKER or liing the corded handset on the telephone base.
 To end the intercom call without answering the incoming call, press
OFF/CANCEL on the handset or CANCEL on the telephone base. You can
also return the corded handset back to the telephone base.
Note: For cordless headsets and speakerphones, refer to the corresponding user’s manual on how to answer
an incoming call during an intercom call.
10:01
PM
10/15
Intercom
BASE 0
is calling