AT&T CL84307 - Telephone Base and Charger Installation; Charger Installation

Getting started
9
Telephone base and charger installation
Install the telephone base and charger, as shown below.
The telephone base is ready for tabletop use. If you want to change to
wall-mounting, see Installation options on page 14 for details.
IMPORTANT INFORMATION
 Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
 The power adapters are intended to be correctly oriented in a vertical or oor mount position.
The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-
table or cabinet outlet.
Telephone base installation
Charger installation
Plug the large end of
the telephone base
power adapter into
a power outlet not
controlled by a wall
switch.
Plug one end of the telephone
line cord into a telephone jack
or a DSL lter.
If you have DSL high-speed
Internet service, a DSL lter
(not included) is required.
Route the telephone line
cord through this slot.
Plug the other end
of the telephone
line cord into the
telephone jack on
the back of the
telephone base.
Plug the small end of the
telephone base power adapter
into the power adapter jack
on the back of the telephone
base.
Route the power adapter
cord through this slot.
Raise the antenna.
Plug the power adapter into a
power outlet not controlled by a
wall switch.
Plug the other
end of the coiled
handset cord
into the jack on
the back of the
telephone base.