Telephone operation
55
Make, answer and end a call
NOTES:
You can also use your cell phone to answer the call. If you answer with your cell phone, it
disconnects from the telephone base.
If you do not want to answer the call, press REJECT.
When you try to make a cell call but your cell phone is not connected to the base, the
telephone base displays Cellular phone not connected. Please connect to proceed.. Press
CONNECT to connect your cell phone to the telephone system. Refer to Bluetooth connection
from idle mode on page 25 and Connect/disconnect an active device on page 26.
Make a cell call using the cell lines of your telephone system instead of the remote voice
control feature, if you need to press dialing keys (0-9, TONE , QUIET#) during a call.
Call waiting on the cell line
If you subscribe to call waiting service from your cell phone service provider,
and someone calls while you are already on a call, you hear a beep.
Using a cordless handset:
Press CELL 1 or CELL 2 to put your current call on hold and take
the new call.
Press CELL 1 or CELL 2 at any time to switch back and forth
between calls.
-OR-
Press SWAP to switch. To switch back, press CELL 1 or CELL 2 .
Using the telephone base:
Press SWAP on the telephone base. The original call is put on hold and
you take the new call.
Press OPTION on the telephone base. Press qCALLER ID or pDIRECTORY to
highlight Swap Cell X. Press SELECT to resume the original call. The other
incoming cell call is put on hold.
•
•
•
•
•
•
•
•
To Next Page
Loading...
