AT&T CLP99286 - Redial; Review the Redial List; Dial a Redial Entry

Telephone operation
65
Redial
The telephone base and each handset store the last 10 dialed numbers (up
to 30 digits each) in the redial list. The redial entries of each handset and the
telephone base are independent.
Review the redial list
To review the redial list of a handset:
Press REDIAL/PAUSE in idle mode.
Press

CID,

DIR or REDIAL/PAUSE repeatedly to browse through the list.
The handset beeps twice at the end of the list.
Press OFF/CLEAR to exit.
To review the redial list of the telephone base:
Press REDIAL /PAUSE in idle mode.
Press qCALLER ID, pDIRECTORY or REDIAL/PAUSE
repeatedly to browse through the list. The telephone
base beeps twice at the end of the list.
Press CANCEL to exit.
Dial a redial entry
To dial a redial entry on a handset:
1. Press HOME/FLASH, or /SPEA�ER to use the home line, then press
REDIAL/PAUSE to enter the redial list.
2. Press

CID,

DIR or REDIAL/PAUSE repeatedly to browse until the desired
number displays. The handset beeps twice at the end of the list.
3. Press DIAL to dial the number displayed.
-OR-
1. Press CELL 1 or CELL 2 to use the cell line, then press REDIAL/PAUSE
to enter the redial list.
2. Press

CID,

DIR or REDIAL/PAUSE repeatedly to browse until the desired
number displays. The handset beeps twice at the end of the list.
3. Press INSERT to insert the desired number.
4. Press DIAL to dial the number displayed.
1.
2.
3.
1.
2.
3.