AT&T EL52219 Quick Start Guide

2
Installation
Install the telephone base and charger, as shown below. If you subscribe to high-speed
Internet service (DSL - digital subscriber line) through your telephone line, you must

the included wall-mount bracket and refer to Wall-mount installation in the online
user’s manual for details.
Plug the other end
of the telephone
line cord into the
telephone line jack
on the bottom of
the telephone base.

included) is
required if you
have DSL high-
speed Internet
service.
Plug one end of the
telephone line cord into a
telephone wall jack.
Plug the large end of the base power
adapter into an electrical outlet not
controlled by a wall switch.
Route the cords
through the slots.
Plug the small
end of the
base power
adapter into
the power
jack on the
bottom
of the
telephone
base.
Raise the antenna.
Plug the large end of the
charger’s power adapter
into an electrical outlet not
controlled by a wall switch.
Ensure the small end of the charger’s
power adapter is plugged into the power
jack on the bottom of the charger.

AT&T EL52219 Specifications

General

Brand	AT&T
Model	EL52219
Category	Cordless Telephone
Language	English