26
Voice guide
This feature is an alternative way for you to do the basic setup of the answering
system. You can follow the voice guide to record your own announcement, set the
number of rings, and set the message alert tone.
This feature is only available on the cordless handset.
1. Press MENU/SELECT when the handset is idle.
2. Press
CID or
DIR to scroll to Answering sys, then press MENU/SELECT.
3. Press
CID or
DIR to scroll to Voice guide, then press MENU/SELECT. You hear
a voice prompt, “Hello! This voice guide will assist you with the basic setup of your
answering system.“
4. Set up your answering system by inputting designated numbers, as instructed in
the voice guide.
NOTE: You can press
OFF/CANCEL to quit the voice guide at any time.
Number of rings
2, 3, 4, 5, or 6 rings.
You can also select Toll saver. If toll saver is selected, the answering system answers
are no new messages. This feature allows you to check for new messages and avoid
paying long distance charges if you are calling from out of your local area. Unless you
To set the number of rings:
1. Press MENU/SELECT on the handset when it is not in use.
2. Press
CID or
DIR to scroll to Answering sys, then press
MENU/SELECT.
3. Press
CID or
DIR to scroll to Ans sys setup, then press
MENU/SELECT.
4. Press
CID or
DIR to scroll to
#
of rings, then press
MENU/SELECT.
5. Press
CID or
DIR to scroll and choose among 2, 3, 4, 5, 6 or
Toll saver.
6. Press MENU/SELECT to save your setting.
NOTE:
system answers the incoming calls.
# of rings
ECO
3
ECO
To Next Page
Loading...
Need help?
General
