15
Options while on calls
Volume control
While on a call, press
DIR/VOLUME to increase or press
CID/VOLUME to decrease
the listening volume.
NOTE: The handset volume setting and speakerphone volume setting are independent.
Join a call in progress
If a handset is already on a call and you would like to join the call, press
PHONE/FLASH or /SPEAKER on another system handset.
To end the call, press
OFF/CANCEL or place the handset in the telephone base or
charger. The call does not end until all handsets hang up.
NOTES:
X This feature is only applicable to models with more than one handset.
X You can use a maximum of four devices at the same time on an outside call. If you have
Unable to call.
Chain dialing
While on a call, you can initiate a dialing sequence from numbers stored in the
directory, caller ID log or redial list. Doing this can be useful if you need to access
numbers other than telephone numbers (such as account numbers or access codes).
To initiate a dialing sequence from the directory, caller ID log or redial list while on a
call, access the number through the menu system:
1. While on a call, press MENU/SELECT, then scroll to Directory or Caller ID log.
Press MENU/SELECT.
-OR-
While on a call, press REDIAL/PAUSE to show the redial list.
2. Scroll to the desired number. If you are in directory, you can use the dialing keys to
Search by name in the online user’s manual
for more details).
3. Press MENU/SELECT to dial the displayed number.
Redial
Each handset stores the 10 most recently called numbers in the redial list.
1. To review and call numbers in the redial list, press REDIAL/PAUSE in idle mode. The
most recently called number appears on the screen.
2. Press
DIR,
CID or REDIAL/PAUSE repeatedly to scroll through the numbers in the
list.
3. When the desired number appears, press
PHONE/FLASH or /SPEAKER to dial
the number.