27
Call screening
If Call screening is on, the incoming messages can be played through the speaker on
the telephone base or the handsets. You can press
PHONE/FLASH on the handset
to stop recording and speak to the caller.
Call screening at the handset:
If the answering system is turned on and there is an incoming call answered by the
answering system, the handset screen shows To screen call and press [SELECT],
alternately. Press MENU/SELECT on the handset to screen the call.
Call screening at the base:
can temporarily turn on the call screening by pressing PLAY/STOP
or
VOL
incoming call.
Message playback
If there are only new messages or there are both new and old messages, the system
plays only the new messages (in chronological order). If there are no new messages,
the system plays all old messages (in chronological order). When playback begins, the
total number of messages is announced.
You can play messages from either the telephone base or a handset.
On the telephone base, press PLAY/STOP
to listen to messages. Use the
corresponding key on the telephone base to repeat, skip, delete, or adjust the volume
of messages.
On a handset, press MENU/SELECT twice to select Play messages. Use the
corresponding key, as indicated on the screen, to repeat, skip or delete a message.
Delete all old messages
You can delete all old messages in idle mode. Once deleted, you cannot retrieve them.
You cannot delete messages until you have listened to them.
X On the telephone base, press DELETE
twice.
X On a handset:
1. Press MENU/SELECT in idle mode.
2. Press
CID or
DIR to scroll to Answering sys, then press MENU/SELECT.
3. Press
CID or
DIR to scroll to Delete all old, then press MENU/SELECT
To Next Page
Loading...
Need help?
General
