EasyManuals Logo

AT&T GL210 User Manual

AT&T GL210
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
61
Appendix
Troubleshooting
I cannot dial out.
f Try all the suggestions in The display shows No line. I cannot get a dial
tone mentioned above
.
f Make sure you have a dial tone before dialing. The handset may take a
second or two to nd the telephone base and produce a dial tone. This is
normal. Wait an extra second before dialing.
f Eliminate any background noise. Noise from a television, radio or other
appliances may cause the phone to not dial out properly. If you cannot
eliminate the background noise, rst try muting the handset before dialing,
or dialing from another room in your home with less background noise.
f Disconnect the telephone base from the telephone wall jack and plug in a
working telephone. If the other phones in your home are having the same
problem, the problem is in your wiring or telephone service. Contact your
telephone service provider (charges may apply).
f Do not install this phone near a microwave oven or on the same electrical
outlet. You may experience decreased performance while the microwave
oven is operating.
f If your phone is plugged in with a modem or a surge protector, plug the
phone (or modem/surge protector) into a dierent location. If this doesn’t
solve the problem, relocate your phone or modem farther apart from one
another, or use a dierent surge protector.
f Relocate your phone to a higher location. The phone may have better
reception when installed in a high area.
f Disconnect the telephone base from the telephone wall jack and plug in a
working telephone. If the other phones in your home are having the same
problem, the problem is in your wiring or telephone service. Contact your
telephone service provider (charges may apply).
The charge light is o.
f Make sure the power and line cords are plugged in correctly and securely.
f Unplug the electrical power. Wait for 15 seconds, then plug it back in. Allow up
to one minute for the handset and telephone base to reset.
f Clean the handset and telephone base charging contacts each month using
a pencil eraser or cloth.

Table of Contents

Other manuals for AT&T GL210

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AT&T GL210 and is the answer not in the manual?

AT&T GL210 Specifications

General IconGeneral
BrandAT&T
ModelGL210
CategoryIP Phone
LanguageEnglish

Related product manuals