AT&T MS2015 - Continued on Next Page

8
Getting started
Deskset installation
Plug one end of the Ethernet cable into the Ethernet jack (
Use only
Supplied
Adapter
L4 L3/4 L2 L1/2
5.1
MS2085 Engraving:
MS2015 Engraving:
Use only
Supplied
Adapter
) at the
back of the deskset, and plug the other end of the Ethernet cable into the
router your console is connected to.
(Continued on next page)
4.
Snap the kickstand into the desired grooves until it locks into place. 3.