AT&T MS2015 - Page 30

24
Getting started
System setup
Network setup (continued)
If you want to switch from Auto set IP to Set static IP, you have to disable the
Auto set IP setting first.
To disable the Auto set IP:
When the deskset is idle, press MENU/SELECT.
Press MENU/SELECT again or /SKIP to select
System Setup.
Press or to scroll to Network Setup, then press
MENU/SELECT or /SKIP.
Press or to scroll to Auto set IP, then press
MENU/SELECT or /SKIP.
Press or to scroll to No, then press MENU/SELECT or /SKIP to save the
setting. To exit without making changes, press CANCEL.
To enable the Static IP:
When the deskset is idle, press MENU/SELECT.
Press MENU/SELECT again or /SKIP to select
System Setup.
Press or to scroll to Network Setup, then press
MENU/SELECT or /SKIP.
Press or to scroll to Set static IP, then press
MENU/SELECT or /SKIP.
The screen displays Enter static IP. Use the dialing
keys to enter a specific IP.
Press DELETE to delete a digit.
Press # to add a dot.to add a dot..
Press /REPEAT or /SKIP to move the cursor to
the left or right.
When entering a specific IP, make sure the IP range is not blocked by the
router. If you are installing more than one deskset in the system, keep
the first three sets of digits consistent and the last one different among
different desksets. For example, if you enter 192.168.1.1 as the static IP
of the first deskset, make sure the first three sets of digits are also set as
192.168.1 in other system desksets.
Press MENU/SELECT to proceed. The screen displays Subnet mask: XXX.
XXX.X.X. Use the dialing keys to enter a specific subnet mask.
Press DELETE to delete a digit.
Press # to add a dot..
Press /REPEAT or /SKIP to move the cursor to the left or right.
1.
2.
3.
4.
5.
1.
2.
3.
4.
5.
•
•
•
6.
•
•
•
Auto Set IP
Yes
>No
Network Setup
Auto set IP
>Set static IP
Discovery Method
Enter static IP
192.168.1._
<’#’ = Add dot>
Subnet mask:
255.255.0._
<’#’ = Add dot>