5
Getting started
Battery installation & charging
Step 4
Charge the remote dial
pad by placing it face
up in the charger. The
CHARGE light is on when
the dial pad battery is
charging.
NOTE:
1. W
hen the battery is charging, you will see the cycling . When the battery is
fully charged, you will see .
2.
If the display on the remote dial pad is blank, try unplugging the power adapter,
and firmly plugging it in again.
IMPORTANT INFORMATION
Use only the supplied rechargeable battery or replacement battery (AT&T
model BT190545). To obtain your replacement battery, visit our website
at www.telephones.att.com, or call 1 (800) 222-3111.
In Canada, dial 1 (866) 288-4268.
CHARGE light
To Next Page
Loading...
Need help?
General
