AT&T TL7601 - Options While on Calls; Call Waiting; Last Number Redial

Options while on calls
Call waiting
If you subscribe to call waiting service with
your local telephone service provider, you
will hear a beep in the headset if there is an
incoming call while you are already on a call.
Press CALL/FLASH on the remote dial pad
or press and hold the MUTE/FLASH key on
the headset to put your current call on hold
and take the new call. Press CALL/FLASH
on the remote dial pad or press and hold the
MUTE/FLASH key on the headset at any time
to switch back and forth between calls.
To end call waiting call, press ON/OFF on the
headset.
When you connect the headset with a corded
phone using LIFTER MODE, press the flash but-
ton on the corded phone to switch back and
forth between calls.
Last number redial
While on a call, pressing or on the
remote dial pad only displays the number
last dialed.
The displayed number is dialed if you
press CALL/FLASH.
Press OFF/CLEAR on the dial pad or press
ON/OFF on the headset to exit the call.
•
•
Remote dial pad operation
14
PHONE 0:00:30
1-234-5678
1
MUTE/FLASH button
NOTES:
1 . Pressing
CALL/FLASH to
access services
from your local
telephone service
provider will not
affect the elapsed
time, which will
continue to record
the total talk time.
2. You cannot press
OFF/CLEAR to exit
call waiting without
ending the call.