AT&T TL92328 User Manual

8
Getting started
Battery installation & charging
Install the battery as shown on the next page. Once you have installed the
battery, the screen indicates the battery status (see table below). If necessary,
place the handset in the telephone base or charger to charge the battery.
For best performance, keep the handset in the charger when not in use. The
battery is fully charged after 16 hours of continuous charging. See the table
on page 95 for battery operating times.
If the screen is blank, you need to charge the handset without interruption for
at least 10 minutes to give the handset enough charge to use the telephone
for a short time. The screen shows LOW BATTERY and the backlight is off
until you have charged the battery without interruption for at least one hour.
The following table summarizes the battery charge indicators and actions
to take.
Battery indicators Battery status Action
The screen is blank. Battery has no charge and the
handset cannot be used.
Charge without interruption
until the screen shows
LOW BATTERY (at least 10
minutes).
The screen shows PLACE IN
CHARGER and flashes.
Battery has very little charge
and the handset cannot be
used.
Charge without interruption
until the screen shows LOW
BATTERY (at least four
minutes).
The screen shows LOW
BATTERY and flashes.
Battery has enough charge to
be used for a short time.
Charge without interruptionwithout interruption
until the screen shows
HANDSET X (at least one
hour).
The screen shows HANDSET X. Battery is charged. To keep the battery charged,
place it in the telephone base
or charger when not
in use.
NOTE: If you are on a phone call in low battery mode, you hear four short beeps
every minute.

AT&T TL92328 Specifications

General

Brand	AT&T
Model	TL92328
Category	Cordless Telephone
Language	English