Bluetooth
Bluetooth setup
To use a Bluetooth-enabled cellular phone with
your telephone, you must first pair and connect
your Bluetooth cellular phone with the telephone
base.
Pairing a device
Before you begin, make sure that your Bluetooth-
enabled cellular phone is not connected to any
other Bluetooth device. Refer to your cellular
phone user's manual to learn how to search for or
add new Bluetooth devices.
To pair and connect a cellular phone:
1. Press and hold the Bluetooth button on the
telephone base until it is flashing. The Bluetooth
feature will be activated.
2. Using your cellular phone, turn on the Bluetooth
feature and search for a new device.
3. Once your cellular phone has found the AT&T
DECT 6.0 telephone base, select it.
4. Using your cellular phone, enter the PIN of the
telephone base (the default PIN is 0000) to
continue the pairing process.
When a device is successfully connected, the
status icon will display on the cordless handset
screen, and the light of the Bluetooth button on
the telephone base will be on steadily.
Auto connection
Once you have paired a device with the
telephone base, the pairing information is stored
in the telephone base. If the paired device
becomes disconnected, the telephone base will
automatically search and re-connect to that device.
If the connection does not resume in a minute, you
will need to re-connect to that device manually,
refer to the section below for details.
Manual connection
To manually re-connect a paired device, make
sure the Bluetooth feature is turned on in your
cellular phone, select AT&T DECT 6.0 from the
paired device list in your cellular phone. Once the
connection is established again, the Bluetooth
button on the telephone base will turn back on.
HANDSET 1
NOTE:
Only one
Bluetooth device
can be paired with
the telephone base
at a time.
17
To Next Page
Loading...
Need help?
General
