66
Answering system
Remote access
You can access your answering system remotely
by dialing your home telephone number from any
touch-tone telephone.
To remotely access your answering system:
1. Dial your telephone number from any touch-
tone telephone.
2. When the system answers, enter the two digit
remote access code (19 is the default code, see
page 60 to change it).
• The system will automatically announce the
number of messages (new and/or old)
if there are any, and then begin to play them.
3. You can also enter the following remote
commands.
Remote commands
1 Press to listen to all messages.
2 Press to hear only new messages.
3 Press to delete the current message
(during playback).
33 Press twice to delete all old messages.
4 Press to repeat the current message
(during playback).
44 Press twice to listen to the previous
message.
5 Press to stop any operation (including
recording).
*5 Press to listen to a list of remote
commands.
6 Press to skip to the next message (during
playback).
*7 Press to record a new announcement.
0 Press to turn the answering system on or
off.
NOTES:
1. If a valid remote access
code is not entered,
the call will be ended
automatically.
2. If you pause for more
than four seconds during
remote access, you
will hear a help menu
listing all features and
commands. If there is no
command for another 20
seconds, the call will end
automatically.
3. If the memory is full, the
answering system will
answer after 10 rings
and announce, "Memory
is full. Enter the remote
access code." Enter your
remote access code to
access the messages and
announcements.
To Next Page
Loading...
Need help?
General
