AT&T U-Verse - Page 10

© 2013 AT&T Intellectual Property. All rights reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property.
Page 5 of 16
Screen elements include the following:
 Close Button: In a step-by-step Setup flow, display ‘Next’ as the label and
display the next screen on tap. In the Settings section, on tap hide this screen
and display the previously displayed screen.
 Instruction text: Display relevant text based upon the following scenarios.
Scenario
Displayed Text
No U-verse Receivers
Detected
There are no U-verse Receivers in your
network. If you have U-verse TV service,
make sure that you are connected to the
same U-verse wireless network as your U-
verse receivers, and that the receivers are
powered ON.
No U-verse Enabled
Receivers Detected
You have not configured any receivers.
Tap on ‘Add New Receiver’ for instructions
on how to connect this device to a receiver.
U-verse Enabled
Receivers Detected
Tap on a receiver name to connect your
device to that receiver.
All Receivers Detected
are U-verse Enabled
Tap on a receiver name to connect your
device to that receiver.
Table 2-1: Display Text
 Available STB List: Display an alphabetically ordered list of all STBs on the
Wi-Fi network that match any of the following criteria:
o STBs with connection mode set to Default.
o STBs with connection mode set to Custom, but pairing code has
already been entered.
STBs with connection mode set to Custom, but no code has yet been entered. In this case, display the
entered. In this case, display the STB name with a lock and details button as shown in the second item in
button as shown in the second item in the list. Tapping on the details icon will display an Add Receiver in
icon will display an Add Receiver in Custom Mode screen. For details, see Section 0
see Section 0