© 2013 AT&T Intellectual Property. All rights reserved. AT&T and the AT&T logo are trademarks of AT&T Intellectual Property.
Page 13 of 16
When the connection process is successful, display the following screen with the
newly added Receiver name added at its alphabetical place in the available
receivers list. Also display a ‘NEW’ tag next to the name if the receiver has just
been added to the list. This tag will be removed once user exits this screen.
Figure 2-6: U-verse Receivers Screen
The newly added receiver should be the one that is currently connected to the
device. All other interactions on this screen remain the same as documented in
Section Figure 2-2 My U-verse Receivers Screen.
For unsuccessful connection, display the applicable Pairing error (Error Code
2-1).
To Next Page
Loading...
