Version 1.0 10/2017
Product Manual—Wireless Video Bridge Gen2
LED
State
Description
O Device not powered
Blinking Blue Booting up
Start within 10 seconds of power ON
Solid Blue Normal operation
Wireless clients (C61W) should have a connection
to the Genie server
Blinking Green Bridge in Survey/Beacon Mode
MoCA network connected
No communication from Genie server to the
WVB2
Solid Green Good connection to the Genie server but no
clients paired with the WVB2
Blinking Yellow No MoCA network detected
[Note: Although issues will be seen on the
wireless client (C61W), the issues are not with the
communication between the WVB2 and C61W]
Solid Yellow MoCA network established
MoCA Phy Rate < 180 Mbps
[Note: Although issues will be seen on the
wireless client (C61W), the issues are not with the
communication between the WVB2 and C61W]
Blinking Green
and Yellow
Wireless Video Bridge Survey/Beacon Mode
No MoCA network established
Blinking Green
and Blue
Wireless Client Add Mode
Solid Red The WVB2 has a good connection to the
Genie server; however, there is a poor wireless
connection to one or more wireless clients
(C61W)
Blinking Red Device error detected
VI. TROUBLESHOOTING
A. WVB2 LED TROUBLESHOOTING
12
To Next Page
Loading...
