Atari CX User Manual

~isasserhbl~
1.
To remove the select switches:
Slide
a. flathead screw driver under the select sw
switches
and pry out the bezel (See Figure 6-6).
Remove the switches.
Pivot Shaft
itch beze
\
4-Joystick Handle
Flathead
Screwdriver
1 between
Fire Button
Fire Buttons
Figure 6-6. Select Switch Bezel Removal
2. Remove the three screws from the bottom controller case.
3. Separate the top controller case from the bottom controller case.
The flex
circuit and key
pad can now be removed.
4. Remove the two fire buttons on each side by pulling them up.
At this point you can check or replace the Flex Circuit Pad and pots, if necessary.
5.
Use the 5200 Controller Knob Puller Tool (FC100214) to remove the joystick
handle.
Push the knob shaft into one of the corners of the
top housing opening. Push
down the boot with the tool to expose the shaft. Push the tool toward the
shaft until the shaft is inside the notch of the tool's head (See Figure
I). Now,
gently lever the tool, and the knob will pop off.
NOTE: By using care, you will not damage the boot during this process.
Be sure to note position of actuator plates and slide block for replacement.
CX52C)O Field Service Manual

Atari CX Specifications

General

Brand	Atari
Model	CX
Category	Home Theater System
Language	English