The adjustment is made for each day. Press
the button to go from one day to the next, which
is indicated by the figures 1 to 7 located on the left
of the screen.
Press quickly to go to the next day and save the
program.
4.9. Program copy function
Keep the
button pressed down for at least 3 seconds to copy the program from one
day to the next. Thus, the factory-memorised program is deleted and replaced by the
program established the previous day.
4.10. Time adjustment
Once the 7 days of the week have been programed, press the
button again to adjust the time:
First, the column of numbers (1-7) on the left flash, select the day by pressing + or – to
place the arrow on the corresponding day.
Press to confirm the day and go onto the time adjustment.
With the hours flashing, press + or – to change the hour.
Press to adjust the minutes.
With the minutes flashing, press + or – to change the minutes.
Press to confirm the time and return to normal mode.
If, for any reason, the electricity supply to the radiator is cut off, the time will remain in the
memory for a maximum of 30 minutes. After this time, the time must be programed into
the radiator again when the electricity supply is re-established.
The program, however, remains in the memory indefinitely.
4.11. Block /unblock of keypad
Keep the + & – buttons pressed for at least 5 seconds until “BLOC” is shown in the display, to
unlock press and hold the + & - button for 5 seconds
8
To Next Page
Loading...
Need help?
General
