SUNRAY PLUS ELECTRIC HEATERS
Dear Customer,
Thank you for choosing SUNRAY PLUS heaters, with their modern design, state-of-the-art
technology, great reliability and quality construction.
ATC SUNRAY PLUS heaters and all their materials and components have passed strict
controls to ensure their quality.
Before starting your heater, please read these instructions carefully as they will ensure the
correct working order of the appliance with the utmost features and to your fullest satisfaction.
1. LOCATION
The radiator should be fitted in the part of the room where the client wants it, depending on the
space available, although preferably on or near outside walls, leaving enough space around the
heater for correct hot air circulation and at least 100 mm, from curtains and furniture, etc. The
distance should be at least 100mm from the floor.
In bathrooms, the electric heater should be outside the protected area, as indicated (zone 3 of
Figure 1) Keep fitting away from bath and showers.
Figure 1: Areas of the bathroom
2. ELECTRIC CONNECTION
The thermal radiator must connect to the mains supply (230V~ 50 Hz.). It is recommended to
install a switched spur for each heater.
In addition the following warnings must be taken into account:
-The electric radiator should not be located underneath a light switch where you need
to stretch over the heater to reach or operate the switch.
To Next Page
Loading...
Need help?
General
