CT1X IP Phone User Manual
ATCOM TECHNOLOGY CO., LIMITE
www.atcom.cn
21
While calling, press the "Transfer" soft key to hold the current call and dial the target number
you want to transfer to on the activated line and press “Send” soft key to call that number.
After the target party answers the call, press "Transfer" soft key again to complete the
transfer.
If the target number has been setup in the current BLF list, and you have already finished the
necessary setup on Webpage of CT1X, there is an easier way to complete the attend transfer.
While calling, press the corresponding BLF key of the target number and then press the
"Transfer" soft key, the attend transfer will be achieved.
The blind transfer allows user to transfer a call without speaking to the third party. On the user
side, the call will be ended as soon as the target phone number is dialed.
Operating steps: Press “Xfer” soft key to get the transfer status, then press “Bxfer” soft key,
input the transfer target number and press “Send” soft key.
If the target number has been setup in the current BLF list, and you have already finished the
necessary setup on Webpage of CT1X, there is an easier way to complete the Blind transfer.
While calling, press the corresponding BLF key of the target number, the blind transfer will be
achieved.
3.7. Mute calls
The input audio will be not transmitted to peer phone after pressing key, To un-mute,
just press key again.
3.8. 3-Way Conference
1. While on calling, press the soft key “Conf”, input the 3
rd
party’s phone number and then
press the softkey “Dial” or press the soft key “Conf” and press the corresponding BLF key
to invite the 3
rd
party to join a conference call.
To Next Page
Loading...
