FG_D6_PROFIBUS_EN_01 / 2020-06-17
“Instruct.”
Fill instruction value
“Drift Unit”
Calibration drifts percent.
“Diff A-Z”
Differential auto reset time.
“FILL MODE”
Type of fill.
“% Drift”
ATR absorption tolerance.
“Start”
Start value of the transient (ATR).
‘IN7:”
Function attributed to the entry of the special
cycles (input 7)
Refer to the “Configurable input
values” table at the end of this chapter
“LANGUAGE”
Choice of the language.
Default language
2nd predefined language
“Max PreFILL”
Maximum pressure value in pre-fill.
Refer to the “Unit” table.
“Leak Rate”
Instruction value during a calibration.
“OFFSET”
Offset on a flow.
“PRESS. AZ”
Piezo reset type.
Before cycle
After cycle
Without auto reset
“Max rej.”
Percents of the bar graph.
To Next Page
