ATEQ VT66MB - 4 Before Starting; Charging; Configuration

ATEQ VT66MB
UM-VT66MB-EN ATEQ VT66MB User manual Page 10/81
4 Before starting
4.1 Charging
Charge the tool before using it the first time. Connect the charging cable to the mains and
to the USB-C port of the tool.
Be sure to charge it regularly, not to fully discharge the battery.
A battery charge indicator is displayed at the top right of the screen, when the tool is
switched on. The battery charge level is given as a percentage.
Battery replacement: to purchase a battery replacement, please contact the
point of purchase.
4.2 Turning the tool on
Press the ON/OFF button for 3 seconds to power up the tool.
Add start image
The start image is displayed.
Add the home screen
image
The home screen is displayed.
The VT66MB tool is ready to use.
Press this button and hold for 3 seconds to switch off the tool.
4.3 Configuration
WiFi connection
To be written
AJOUTER “Register the tool”