Aerosol Photometer
Aerosol Photometer - 2i 10
User Responsibility
The user must:
1. read and comprehend the information contained in
this manual before using the product;
2. have an understanding of the electrical and
mechanical system principles used in the
operation of this photometer;
3. be trained in the proper use of electro-mechanical
equipment;
4. properly use this product for the intended purpose
and follow all regulations and procedures that
apply to the location where this product is used;
5. maintain the product as specified in this manual;
6. maintain and keep in proper working condition any
other equipment associated with the operation of
this product.
Precautions
!
i
Warning – General Safety Rules
Read and understand all instructions. Failure to follow all
instructions listed below may result in electric shock, fire
or serious personal injury. The warnings, cautions, and
instructions discussed in this operation and maintenance
manual cannot cover all possible conditions and situations
that may occur. It must be understood by the operator that
common sense and caution are a factor which cannot be
built into this equipment, but must be supplied by the
operator.
!
Caution – Shipping Hazard
When returning a 2i-N for service, the end user must
remove the potentially contaminated sampling train prior
to shipping the instrument. Refer to the 2i-N addendum for
the proper procedure.
!
Caution –Serviceability
There are no user-serviceable parts inside the instrument.
Refer all repair and maintenance to a qualified factory-
authorized technician.
To Next Page
Loading...
Need help?
General
