Handlebar switches
1. Lights switch “ / ”
2. Engine stop switch “ / ”
3. Start switch “ ”
Engine stop switch “ / ”
Set this switch to“ ”before starting the engine.
The engine stop switch controls the ignition and
stops the engine when it is running. Use this switch
to stop the engine in an emergency situation. The
engine will not start or run when this switch is set
to “ ”.
Start switch “ ”
Push this switch to crank the engine with the starter.
See the starting instructions prior to starting the engine.
Light beam switch “ / ”
Set this switch to“ ”to turn on the low beams
and the taillight. Set the switch to “ ”to turn on
the high beams and the taillight.
NOTICE
Do not use the headlights with the engine turned off for
an extended period of time, otherwise the battery
may discharge to the point that the starter motor will
not operate properly. If this should happen, remove
the battery and recharge it.
To Next Page
Loading...