OPERATION
Read the owner’s Manual carefully before riding the ATV.
If there is a control or function you do not understand,
ask your dealer.
WARNING
Read the Owner’s Manual carefully to become
familiar with all controls in order to help prevent any
loss of control, which could cause an accident or injury.
Starting a cold engine
NOTICE
See the “ Engine break-in” section prior to operating
the engine for the first time.
1. Set the parking brake.
2. Turn the fuel cock to“ON”.
3. Turn the key to “ON” and the engine stop
Switch to “ ”.
4. Shift the transmission into neutral. The neutral Indicator
light should come on. If the indicator lights does not
come on, have a dealer check the electrical circuit.
TIP
This model is equipped with an ignition circuit cut off system.
The engine can be started under the following conditions.
● The transmission is in neutral
5. Completely close the throttle lever and start the engine
by pushing the start switch.
TIP
If the engine fails to start, release the start switch, then push
it again. Pause a few seconds before the next attempt.
Each cranking should be as short as possible to preserve
battery energy. Do not crank the engine more than 10 seconds
on each attempt.
NOTICE
For maximum engine life, never accelerate hard when the
engine is cold!
Starting a warm engine
Follow the same procedures as for starting a cold engine.
Instead, start the engine with the throttle slightly open.
To Next Page
Loading...