Installing a wheel
1. Place the ATV on a level surfaces.
2. Install the wheel and nuts.
3. Lower the ATV to the ground.
4.Tighten the wheel nuts to the specified torques.
Troubleshooting
Although the ATVs receive a thorough inspection before
shipment from the factory, trouble may occur during operation.
Any problem in the fuel, compression, or ignition systems, for
example, can cause poor starting and loss of power.
The following troubleshooting chart represents a quick and easy
procedure for checking these vital systems yourself. However,
should your ATV require any repair, take it to a dealer, whose
skilled technicians have the necessary tools, experience, and
know-how to service the ATV properly. Use only original
replacement parts.
WARNING
Do not smoke when checking the fuel system. Fuel can
ignite or explode, causing severe injury or property
damage. Make sure there are no open flames or spark in
the area, including pilot lights from water heaters or
furnaces.
To Next Page
Loading...